How to install the washbasin faucet?

washbasin faucet

Steps to install the washbasin faucet of the face pot:

Step 1: Take out the faucet of the pelvic basin and check whether all the accessories are complete. Before installation, you must remove the dirt around the installation hole and the water supply pipeline to ensure that there is no impurities in the pipeline of the pot water pipe in the water pipe. In order to protect the faucet's surface not being scratched, it is recommended to wear gloves for installation.

Step 2: Take out the pelvan Bathroom Faucet rubber cushion ring. The cushion ring is used to alleviate the pressure of the metal surface of the faucet metal, protect the ceramic basin, then insert a water pipe, and spin.

Step 3: Put the thread connector into the first water pipe, and then pass the second water pipe pipe through the water intake end of the water through the thread connector.

Step 4: Spin the second water pipe into the water inlet port. Pay attention to the correct direction, balanced force, and then tighten the thread connector.

Step 5: Put the two water pipes into a white glue pad.

Step 6: Put the locking nut to fix the faucet.

Step 7: Then tighten the sleeve.

Step 8: Lock the two water inlet pipes and corner valve interfaces respectively. Do not twist the pipe pliers to prevent deformation or even twist. Pay attention to the connection of hot and cold water. Connect the water corner valve on the other end of the water pipe.